INSPECT SWITCH CONTINUITY. (a) Using an ohmmeter, check that no continuity exists be- tween the terminal and switch body when the coolant temperature is ...
INSPECTION 1. DRAIN ENGINE COOLANT FROM RADIATOR HINT: It is not necessary to drain out out all the coolant.
2. (a) (b)
REMOVE WATER TEMPERATURE SWITCH Disconnect the connector. Remove the water temperature switch.
I13992
3. (a)
Ohmmeter
P06722
INSPECT SWITCH CONTINUITY Using an ohmmeter, check that no continuity exists between the terminal and switch body when the coolant temperature is above 83 °C (181 °F). If continuity exists, replace the switch. (b) Using an ohmmeter, check that continuity exists between the terminals when the coolant temperature is below 90 °C (194 °F). If no continuity exists, replace the switch. 4. (a) (b) 5.
INSTALL WATER TEMPERATURE SWITCH Install the water temperature switch. Torque: 34 N·m (350 kgf·cm, 25 ft·lbf) Connect the connector. FILL WITH ENGINE COOLANT
CIRCUIT DESCRIPTION. The door unlock detection switch is built in the door lock motor assembly. This switch is ON when the door lock knob is in the unlock ...
CIRCUIT DESCRIPTION. The key unlock warning switch goes ON when the ignition key is inserted in the key cylinder and goes OFF when the ignition key is ...
Jun 3, 2011 - Gonadogenesis 4 Reproduction 4 Sex steroids 4. Temperature. Introduction. The Earth's climate has warmed by approximately. 0.74°C over ...
When you push the SinkTop Switch⢠button, you switch electrical power between the two outlets on the power module. This feature allows a second appliance ...
texture was about 1:1 sand and loam). A slow releasing fertilizer ..... hydraulic, and canopy boundary layer properties: do stomata. Fennell A, Markhart AH. 1998.
(b) Install the coil spring to the shock absorber. HINT: Fit the lower end of the coil spring into the gap of the spring low- er seat. (c) Install the upper insulator with ...
When installing the front seat outer belt, take care that the wiring does not interfere with other parts and is not pinched between other parts. 1. INSTALL FRONT ...
INSTALLATION. 1. INSTALL ELECTRIC COOLING FAN TO RADIATOR. Install the cooling fan with the 3 bolts. Torque: 7.5 N·m (80 kgf·cm, 66 in.·lbf). 2. INSTALL ...
(a) Fasten the front seat belts. (b) Drive the car at 10 mph (16 km/h) and slam on the brakes. Check that the belt locks and cannot be extended at this time. HINT:.
NOTICE: Be careful not to damage the serrations. (c) Install the spacer. (d) Coat a new oil seal lip with molybdenum disulfide lithium base grease. (e) Using SST ...