INSPECTION 1. INSPECT DISASSEMBLED PARTS Inspect the disassembled parts for wear, rust or damage.
BR4081
2. MEASURE BRAKE SHOE LINING THICKNESS Using a ruler, measure the shoe lining thickness. Standard thickness: 4.0 mm (0.157 in.) Minimum thickness: 1.0 mm (0.039 in.) If the thickness is less than the minimum or shoe lining shows signs of uneven wear, replace the brake shoes. HINT: If a brake shoes needs replacing, the brake shoes must be replaced as a set 3. MEASURE BRAKE DRUM INSIDE DIAMETER Using a brake drum gauge or equivalent, measure the inside diameter of the drum. Standard inside diameter: 180.0 mm (7.087 in.) Maximum inside diameter: 181.0 mm (7.126 in.) If the drum is scored or worn, the brake drum may be lathed to the maximum inside diameter.
F06408
4.
INSPECT REAR BRAKE LINING AND DRUM FOR PROPER CONTACT If the contact between the brake lining and drum is improper, repair the lining with a brake shoe grinder, or replace the brake shoe assembly.
Try to rotate the clutch pinion gear counter- clockwise and check that it locks. If necessary, replace the starter clutch. 13. INSPECT MAGNETIC SWITCH.
75.000 - 75.013 mm (2.95275 - 2.95326 in.) Maximum diameter: 75.013 mm (2.95326 in.) If the diameter is greater than maximum, replace the cylinder block. 6.
(a) Fasten the front seat belts. (b) Drive the car at 10 mph (16 km/h) and slam on the brakes. Check that the belt locks and cannot be extended at this time. HINT:.
CIRCUIT DESCRIPTION. The vehicle speed sensor outputs a 4-pulse signal for every revolution of the transaxle output shaft. After this signal is converted into a ...
When all the component parts, wire harnesses and con- nectors of each circuit except the ECU are found to be normal in troubleshooting, then it is determined ...
AC Form 8050-2, Aircraft Bill of. Sale (kit aircraft only) ... Purchase a logbook for the air- frame, engine, and ... FAA Order 8130.2, "Airworthiness. Certification of ...
Other types include hinged doors in ply-covered structures or .... George C. Prill, Director of the FAA's Flight Stan- dards Service, said the data is needed to evaluate and plan the maintenance airman certification and surveillance pro- gram.
fumes are poisonous and can cause loss of consciousness and death in a short time. Never drain the float bowl when the engine is hot. Severe burns may result.
(b) Install the coil spring to the shock absorber. HINT: Fit the lower end of the coil spring into the gap of the spring low- er seat. (c) Install the upper insulator with ...
When installing the front seat outer belt, take care that the wiring does not interfere with other parts and is not pinched between other parts. 1. INSTALL FRONT ...
INSTALLATION. 1. INSTALL ELECTRIC COOLING FAN TO RADIATOR. Install the cooling fan with the 3 bolts. Torque: 7.5 N·m (80 kgf·cm, 66 in.·lbf). 2. INSTALL ...
NOTICE: Be careful not to damage the serrations. (c) Install the spacer. (d) Coat a new oil seal lip with molybdenum disulfide lithium base grease. (e) Using SST ...