6.2.User’s Manual Requirement of FCC/IC rules FCC/IC User's manual requirements that are required by FCC/IC rules are described on user's manual of the vehicle as followings; 『" NXH-0628, NXH-0828, DVZ-0528 and DVZ-0728 " are installed in motor vehicle, " NXH-0628, NXH-0828, DVZ-0528 and DVZ-0728 " have no manual for user. So, following FCC/IC user’s manual statement will be stated in user’s manual of the motor vehicle.』 ■FCC ID FCC for NXH0628 NXH0828 DVZ0528 DVZ0728
FCC ID:AJDK053 This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines in Supplement C to OET65. This equipment has very low levels of RF energy that it deemed to comply ■OET65 caution without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles). ■Co-Location This transmitter must not be co-located or operated in conjunction with any other caution antenna or transmitter. This device complies with part 15 of the FCC Rules. Operation is subject to the following ■Statement two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired FCC WARNING ■FCC Changes or modifications not expressly approved by the party responsible for compliance WARNING could void the user's authority to operate the equipment. ■IC ID
■RSS-102 caution IC for NXH0628 NXH0828
■Antenna caution
■Statement
IC:775E-K053 This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is desirable that it should be installed and operated keeping the radiator at least 20cm or more away from person’s body (excluding extremities: hands, wrists, feet and ankles). Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioé lectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation de l’exposition maximale autorisée. Cependant, cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le dispositif rayonnant et le corps (à l’exception des extrémités : mains, poignets, pieds et chevilles). Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication. Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage radioé lectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l' établissement d'une communication satisfaisante. This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
2 nov. 2015 - (2) this device must accept any interference received, including ... cause harmful interference to radio or television reception, which can be ...
14 août 2017 - Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et. (2) l'u
The device under test is manufactured by the grantee (Continental Corporation) and sold as an. OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etcâ¦, the grantee must ensure the end-user has all applicable / appropriate operating instr
radioélectrique aux autres utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication réussie. This radio
Make sure the power door locks to confirm you are in the programming mode. 7) Press the LOCK ... button to confirm that the system has accepted the remote.
Important Note: To comply with the FCC/IC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjuncti
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or mor
Programming Instructions: 1) Turn vehicle ignition key to ON position, without starting engine (Key-On Engine-Off - Position "1"). 2) Insert Programmer into OBD connector DLC port ( - located under steering column, near pedals). Green LED should turn
The term âIC:â before the radio certification number only signifies that Industry Canada technical specifications were met. FCC ID: MRXTMS5. IC: 2546A-TMS5.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and. (2) this device must accept any interference received, including interference that may
continued FCC and Industry Canada regulatory compliance. ... This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of.
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. WARNING: Changes or modifications not expressively approved by the party responsible for co
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installati
FCC CAUTION. The transmitter for the remote keyless. â¡Locking the doors. ã»Danger of explosion if battery is incorrectly. Changes or modification not expressly entry system is located inside the key head. Press the " " button to lock all doors and
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the rece
18 août 2015 - This equipment has been tested and found to comply with the limits fora Class B digital device, pursuant to Part 15 of ... equipment does cause harmful interference to radio or television reception, which can be determined by ... Over
3 nov. 2014 - This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction ...
thumb or index finger. Peel the. MagicBand swiftly for best results. Make sure the ... pouce ou de l'index. Pelez le Magic-. Band rapidement pour un meilleur.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will n