This equipment complied with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Le présent appareil est conforme aux CNR d'industrie Canada applicables aux appareils radio exem pts de licence L'exploitation est autorisée aux deux conditions suivantes: 1) I'appareil ne doit pas produire de brouillage, et 2) I'utillsateur de I'appareil doit accepterbrouillage radioélectrique subi meme si le brouillage est susceptible d'encompromettre le fonctionnement. mauvais fonctionnement de I'appareil. NMB-3 (B)
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouil
exposure compliance. This transmitter must not be co- located or operating in conjunction with any other antenna or transmitter. The portable device is designed ...
is subject to the following two conditions: (1) The devices may not cause ... not emit RF field in excess of Health Canada limits for the general population. Consult ...
Important Note: To comply with the FCC/IC RF exposure compliance requirements, a separation distance of at least 20 cm must be maintained between the antenna of this device and all persons. This device must not be co-located or operating in conjuncti
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and. (2) This device must accept any interference received, including interference that may
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will n
Firstech, LLC. | 2. QUICK START CARD. 1 WAY 4 BUTTON REMOTES. If you have an alarm and optional LED(s) installed, it will flash once a second if armed.
The power door locks will cycle when you have successfully entered ... If programming has failed, repeat this procedure from the beginning. ... Changes or modifications not expressly approved by Dorman Products Inc. could void the user's ...
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that
This device complies with Industry Canada licence-exempt RSS standard(s). Operation ... (e.i.r.p.) is not more than that necessary for successful communication.
Changes or modifications not expressly approved by the party responsible for compliance could void the ... user's manual in accordance FCC & IC requirements.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
digital device, pursuant to part 15 of the. FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. â This equipment generates, uses and can radiate radio frequency energy an
This device complies with Part 15 of the FCC Rules and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and. (2) this device must accept any inte
NOTE:The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could ...
This device complies with Part 15 of the FCC Rules. ... Caution: Any changes or modifications not expressly approved by the party responsible for compliance.
FCC/IC Notices. This device complies with Part 15 of FCC. Rules and RSSÐGen of IC Rules. Operation is suEMect to the following two conditions: (1) this device may notcauseäinterference, and. (2) this device must accept any interference, including
Apple Confidential. iPad RF Exposure information. iPad has been tested and meets applicable limits for radio frequency. (RF) exposure. Specific Absorption Rate (SAR) refers to the rate at which the body absorbs RF energy. The SAR limit is 1.6 watts p
Programming Instructions: 1) Turn vehicle ignition key to ON position, without starting engine (Key-On Engine-Off - Position "1"). 2) Insert Programmer into OBD connector DLC port ( - located under steering column, near pedals). Green LED should turn
Le present appareil est conforme aux CNR d'Industrie Canada app licables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et. (2) l'utilisateur de l