-0.3 to 18. V. IO. Output Current for VCC. + ≥ 15V. ±30. mA. Iin. Input Current ..... 2.54. 0.100 e3. 7.62. 0.300 e4. 7.62. 0.300. F. 6.6. 0260 i. 5.08. 0.200. L. 3.18.

Typ. Max. Units. VOS. Input Offset Voltage. RS = 50Ω. 0.3. 5. mV. IOS. Input Offset Current. 10. 200. nA ... ±10. ±12.5. V. VCM. Common Mode Input Voltage. ±12. ±14.0. V. CMRR. Common Mode .... Support Center. Email: [email protected].

OperationalAmplifier. February 1995. LM837 Low Noise Quad Operational Amplifier. General Description. The LM837 is a quad operational amplifier designed ...

Europe Customer Support Center. Fax: +49 (0) 180-530 85 86. Email: [email protected]. Deutsch Tel: +49 (0) 69 9508 6208. English. Tel: +44 (0) 870 ...

DESCRIPTION. These circuits consist of two independent,high gain, internally frequency compensated which were designed specifically to operate from a single ...

Sep 12, 2006 - The result is an op amp with exceptional sound quality. The low-noise .... see end of data sheet, or Appendix C of Burr-Brown IC Data Book.

Lead Temperature (Soldering, 10 sec.) 260˚C ... RL =2kΩ. ±10. ±13. ±10. ±13. V. Input Voltage Range. VS = ±15V. ±12. ±12. V ... Email: [email protected].

the OP27 ideal for precision instrumentation applications. Exceptionally low .... Changes to Ordering Guide . .... POWER SUPPLY REJECTION RATIO. PSRR.

n Low distortion: 0.01% at 10 kHz ... (Note 10). Output Short Circuit to V−. (Note 2). Lead Temperature. (Soldering, 10 sec.) ..... Email: [email protected].

24. V. Swing. VOL V+ = 5V, RL = 10 kΩ. 5. 20. 5. 100. mV. Output Current. Source VIN. + = +1V, VIN ..... Dimensioning and tolerancing per ASME Y14.5M-1994.

ground. □ Differential input voltage range equal to the power supply voltage. □ Large output voltage swing 0V to (Vcc - 1.5V). Description. These circuits consist ...

MOTOROLA ANALOG IC DEVICE DATA. Precision Operational. Amplifier. The LM308A operational amplifier provides high input impedance, low input offset ...

The LM381 LM381A is a dual preamplifier for the amplifica- tion of low level signals in applications requiring optimum noise performance Each of the two ...

Input Referred Cross Talk f = 20∼20 kHz. −120. dB. LM833 .... which, (a) are intended for surgical implant into the body, or. (b) support or sustain life, and whose ...

DC ELECTRICAL CHARACTERISTICS (VCC = +15 V, VEE = –15 V, RL .... Bidirectional DC Motor Control with ... The maximum power consumption an integrated circuit .... or authorized for use as components in systems intended for surgical implant into the

Description. The L272 is a high-power dual operational amplifier provided as a 8-DIP and 16-SOP package. The operational amplifier is designed for low ...

Low Power Dual Operational Amplifiers. General Description. The LM158 series consists of two independent, high gain, internally frequency compensated ...

gain blocks and all the conventional op amp circuits. • Differential Input Voltage .... also lateral NPN parasitic transistor action on the IC chip. This transistor action ...

description. The TL322C and the TL322I are dual operational amplifiers similar in performance to the uA741 but with several distinct advantages. They are.

Aug 3, 2001 - DESCRIPTION. The 5532 is a dual high-performance low noise operational amplifier. Compared to most of the standard operational amplifiers, ...

3.1 Basic Loop Filter Design Procedure. ..... After the supply voltage is switched on, the different registers are loaded with following preset values.

A close in noise value of -86.5 dBc/Hz has been measured in the loop bandwidth ..... is settled (i.e. acceptable frequency or phase error with respect to target). .... In this section, a design example based on the third order PLL for GSM is shown.

will be available for download from (see section IC OpAmps): http://www.sg-acoustics.ch/analogue audio/. The reader will note that there are various amplifiers ...

Office Distributors for availability and specifications. Supply Voltage. LM709 LM709A LM709C. g18V. Power Dissipation (Note 1). LM709 LM709A. 300 mW.