Wall GENERAL PRODUCT INFORMATION: This product is listed by one of the following “Nationally Recognized Testing Laboratory”
CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved.
These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is suitable for damp locations.
Use minimum 90°c supply conductors.
This product may be dimmed with a low voltage electronic dimmer. This instruction shows a typical installation.
1A
COVER
SHADE
6 MOUNTING PLATE SCREW
SHADE BASE
JUNCTION BOX
1
1
3
4
MOUNTING PLATE
ALLEN SCREW ALLEN WRENCH
1
Secure the mounting plate to the electrical box with the two mounting plate screws.
2
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
3
Connect the white driver wire to the neutral power line wire with a wire nut.
4
Connect the black driver wire to the hot power line wire with a wire nut.
5
Mount the fixture base onto the mounting plate and secure it with the Allen screw using an Allen wrench.
6
Install the shade by placing it over the shade base and securing it in place by screwing on the cover. Repeat for remaining shades.
1
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne.
Utiliser les conducteurs d'alimentation supérieure à 90° c.
1A
COUVERCLE
ABAT-JOUR
6 VIS DE MONTAGE BOÎTE DE JONCTION
BASE DE ABAT-JOUR
1
1
3
4
PLAQUE DE MONTAGE
VIS DE ALLEN CLÉ ALLEN
1
Fixez la plaque de montage à la boîte de jonction avec les deux vis de montage.
2
Connectez le fil de terre de luminaire à un terrain approprié conformément aux codes électriques locaux.
3
Connectez le fil blanc de conducteur au fil de la ligne d'alimentation neutre avec un écrou de fil.
4
Connectez le fil noir de conducteur au fil de la ligne d'alimentation chaude avec un écrou de fil.
5
Montez la base de luminaire sur la plaque de montage et le fixer avec la vis Allen à l'aide d'une clé Allen.
6
Installez l'abat-jour en le plaçant sur la base de l'abat-jour et le fixer en place par vissage sur la couvercle. Répétez l'opération pour l'abat-jours restants.
2
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan.
Utilizar conductores de suministro mínimo 90° c.
1A
CUBIERTA
PANTALLA
6 TORNILLO DE MONTAJE CAJA DE JUNCTURA
BASE DE LA PANTALLA
1
1
3
4
PLACE DE MONTAJE
TORNILLO DE ALLEN LLAVE DE ALLEN
1
Fije la placa de montaje a la caja eléctrica con los dos tornillos de montaje.
2
Conecte el cable de tierra de la lámpara a un terreno adecuado, de acuerdo con los códigos eléctricos locales.
3
Conecte el cable conductor blanco al cable de línea de energía neutra con una tuerca para cable.
4
Conecte el cable conductor negro al cable de línea eléctrica caliente con una tuerca para cable.
5
Monte la base de la lámpara en la placa de montaje y fijarlo con el tornillo Allen con una llave Allen.
6
Instale la pantalla colocándolo sobre la base de la pantalla y manteniéndola en su lugar atornillando la cubierta. Repita para las pantallas restantes.
Disconnect or turn off power before installation or servicing. ▻ Verify that supply ... Allow for some volume of airspace around the fixture. Avoid covering LED ...
Connect the white driver wire to the neutral power line wire with a wire nut. ... Insert the glass panels into the housing and secure them using the glass panel ...
Drill appropriate size holes at the marked locations and install the anchors. ... This product is safety listed for damp locations. ... CAUTION RISK OF FIRE.
Aurora Limited 16 Alban Park Hatfield Road St Albans Hertfordshire AL4 0JJ ... This product is guaranteed for a period of 2 years from the date of purchase.
IP54 rated luminaires are protected against splashing water from all directions when correctly installed. It is suitable for installation in locations containing a bath ...
Note: Actual depth of box to be determined in accordance with the NEC and local ordinances. Indoor or outdoor frame mounted junction box: Raco 2” x4” (16.5 ...
código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de ...
Port Washington, NY 11050. Central Distribution Center ... Place the fixture over the mounting plate and secure it with mounting screws (B). NOTE: DIMMING ...
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous ... Coloque el interruptor de ali mentación.
household or commercial waste. Aurora does not levy any WEEE disposal charges to its customers for affected WEEE related products. To prevent possible harm to the environment or human health from uncontrolled waste disposal, please separate any such
Drill holes on the wall aligned with the keyhole location on the cover plate. 4. Insert plastic anchors (C) into the holes. Insert wood screws (A) into the plastic ...
CAUTION. - All parts must be used as indicated in these instructions. Do not substitute any parts, leave parts out, or use any parts that are worn out or broken.
Do not substitute any parts, leave parts out, or use any parts that are ... of our products at any time as part of the company's continuous improvement program.
TUMBLER. 1500 x 180 x 24/15 mm i= p. NL. Deze wandbekleding met smalle repen diep gerookt eikenhout geeft een stijlvolle designerlook aan je interieur ...
Install the finials to the top and bottom of the fixture using the screws and washers. Follow enclosed supplement installation instructions for electrical and fixture installation onto junction box. Screw the lamp into the socket. Refer to the label
οο οο ν ν * Ï Ï Ï Î Î Ï Î¿. I I J c ( ( x + + ( + 3 k + + x < 0 / 1 X X 0 + (( k c º # X X 0 - 2 c 0 # + c + 0 + c I | as xx c c eeeeee â¡â¡CIU + I IU â¡ - UC (%001 $ X # + r ...
Wall Box. 1 seule ouverture, 4.8 cm (1.89 po) profondeur, ivoire. Part No.: 517003. Caractéristiques: Pour le câblage réseau. 1 seule ouverture. Inclut des vis de ...