... or modifications not expressly approved by the manufacturer responsible for compliance could void the ... This device complies with Part 15 of the FCC Rules.
FOR PRODUCT SOLD IN USA • POUR LES PRODUITS VENDUS AUX ÉTATS-UNIS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. • This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. NOTE: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment. Cet appareil est conforme à l'article 15 de la réglementation de la FCC. L'utilisation de ce dispositif est autorisée seulement aux deux conditions suivantes : (1) il ne doit pas produire de brouillage nuisible, et (2) l'utilisateur du dispositif doit être prêt à accepter tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre le fonctionnement du dispositif. • Cet appareil a été testé et jugé conforme aux limites de la classe B pour un appareil numérique en vertu de l'article 15 de la réglementation de la FCC. Ces limites ont été instaurées pour fournir une protection raisonnable contre toute interférence nuisible dans une installation résidentielle. Cet appareil génère, utilise et peut émettre de l'énergie radiofréquence. S'il n'est pas installé et utilisé conformément aux instructions, il peut provoquer des interférences sur les communications radio. Cependant, il n'est pas garanti que des interférences ne se produiront pas dans certaines installations. Si cet appareil cause des interférences à la réception radio ou télévisée (ce qui peut être vérifié en éteignant l'appareil puis en le remettant sous tension), l'utilisateur peut tenter de les résoudre en suivant une ou plusieurs des mesures ci-après : • Réorienter ou déplacer l'antenne réceptrice. • Augmenter l'espace entre l'appareil et le récepteur. • Brancher l'appareil sur une prise de courant différente de celle sur laquelle le récepteur est branché. • Pour obtenir de l'aide, contacter le vendeur ou un technicien radio/télévision expérimenté. REMARQUE : Tout changement ou modification de cet appareil n'ayant pas été expressément approuvé par les parties responsables de sa conformité peut entraîner l'annulation du droit d'exploitation de l'équipement par l'utilisateur.
FOR PRODUCT SOLD IN CANADA • POUR LES PRODUITS VENDUS AU CANADA CAN ICES-3 (B)/NMB-3(B) Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. L’utilisation de ce dispositif est autorisée seulement aux conditions suivantes : (1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will n
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and. (2) This device must accept any interference received, including interference that may
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: - Reorient or relocate the rece
The power door locks will cycle when you have successfully entered ... If programming has failed, repeat this procedure from the beginning. ... Changes or modifications not expressly approved by Dorman Products Inc. could void the user's ...
Federal Communication Commission Interference Statement. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
22 janv. 2013 - Farmington Hills, MI 48335-2642. Tel 248.478.7210. Fax 248.699.4241. RE: Certification for Chrysler MY2014 KL/DS Sensor. Model #:. 68157568AA, 68186572AA, 68186575AA. FCC ID: GQ4-61T. Canada IC: 1470A-42T. User's Manual and Compliance
L'utilisateur de l'appareil doit accepter tout brouillage radioelectrique subi, meme si le brouillage est susceptible d'en compromettre le fonctionnement. WARNING: Changes or modifications not expressively approved by TRW Automotive U.S. LLC could vo
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following ...
THE COLOURS INDICATED HERE MAY NOT APPEAR SAME IN THE FINAL PROOF. ALTHOUGH. EVERY EFFORT HAS BEEN MADE TO CHECK THE CORRECTION OF LAYOUT AND TEXT. IT IS CLIENT RESPONSIBILITY TO VERIFY BEFORE GIVING THE FINAL APPROVAL. TR00049_HK_One_QSG_A. Version
When charging the battery for the very first time, you should charge it for at least 8 hours. (using the AC charger) with your device turned off. 1. Push the tap outwards, plug the converter to the AC charger and then push the tap inwards to lock the
Programming Instructions: 1) Turn vehicle ignition key to ON position, without starting engine (Key-On Engine-Off - Position "1"). 2) Insert Programmer into OBD connector DLC port ( - located under steering column, near pedals). Green LED should turn
Le present appareil est conforme aux CNR d'Industrie Canada app licables aux appareils radio exempts de licence. L'exploitation est autorisee aux deux conditions suivantes: (1) l'appareil ne doit pas produire de brouillage, et. (2) l'utilisateur de l
18 juil. 2016 - may lead to the violation of FCC/IC limit and is prohibited. Installation procedure. Please refer to user's manual for the detail. w Warning: Please carefully select the installation position and make sure that the final output power
Make sure the power door locks to confirm you are in the programming mode. 7) Press the LOCK ... button to confirm that the system has accepted the remote.
is subject to the following two conditions: (1) The devices may not cause ... not emit RF field in excess of Health Canada limits for the general population. Consult ...
Google Playâ¢. Google Chromeâ¢. Google Play is a trademark of Google Inc. The Google Play store allows you to download apps, music, movies, and games ...
U.S.. FCC Notices. FCC ID: BKMAE-H714RX. Contains FCC ID: BKMAE-E207. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device mu
communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or ... For telecommunication type connectors and terminals not used for connectio
When end-user instructions are required, as in the case of this product, the ... manual to ensure continued FCC and Industry Canada regulatory compliance.
14 juil. 2014 - Pick the Local Package Directory (this is the download cache directory). 5. ... Confidential. 9-1. Run normal F/W. æå½±çç·¨è 19. Open OS terminal and set USB comport (reference to page9 ), set baud- rate as 115200 off off ... Th