Transmission Fluid Temperature Sensor Malfunction (ATF Temperature Sensor)
DTC
P0711
Transmission Fluid Temperature Sensor Circuit Range/Performance Problem
CIRCUIT DESCRIPTION The ATF temperature sensor converts fluid temperature into a resistance value which is input into the ECM. DTC No.
DTC Detecting Condition
Trouble Area
P0710
Either (a) or (b) is detected for 0.5 sec. or more. (2-trip detection logic) (a) Temperature sensor resistance is less than 79 Ω (b) After the engine has been operating for 15 minutes or more, the resistance at the temp. sensor is more than 156 kΩ
Open or short in ATF temperature sensor ATF temperature sensor ECM
P0711
Both (a) and (b) is detected. (a) After 12 seconds of the engine start, the temp. of the atmosphere and that of the engine coolant is more than -10°C. (b) After a normal driving for over 20 minutes and 6.2 miles (10 km), the ATF temp. is less than 10°C.
Open in ATF temp. sensor circuit ATF temp. sensor ECM
WIRING DIAGRAM
ECM
ATF Temperature Sensor O
6
O
1 E1
Y
10 E5
OIL
9 E6
E2
E1
BR
D07917
2002 ECHO (RM884U)
Author:
Date:
340
DI-171 DIAGNOSTICS
-
AUTOMATIC TRANSAXLE
INSPECTION PROCEDURE 1
Check ATF temperature sensor. 6
1 D02967
PREPARATION: Remove the solenoid wiring (See page AX-9 ). CHECK: Measure resistance between terminals of ATF temperature sensor at 25 °C (77 °F) and 110 °C (230 °F). OK: Resistance (Approx.): 25 °C (77 °F): 3.5 kΩ 110 °C (230 °F): 247 Ω NG
Replace the solenoid wiring.
OK
2
Check harness and connector between solenoid wiring and ECM (See page IN-29 ).
Use the check-boxes to mark your progress. â Please read the ... IC socket. Watch the position of the notch! â R2 : 18K (1 - 8 - 0 - 2 - 1). â R7 : 1K8 (1 - 8 - 0 - 1 ...
The No.1 vehicle speed sensor outputs a 4-pulse signal for every revolution of ... â¢Open or short in vehicle speed sensor circuit ... INSPECTION PROCEDURE.
Modelling fluid flow and heat transfer inside a mini- or micro-channel constitutes a ... well as a model of conjugated transfer [5] in the three layers of the system ...
5-year warranty. Enroll by placing the panel into wireless enrollment mode ... Current Draw. Transmitted Indications. 433.92 MHz. One Panasonic CR123A.
T-Off. Trim. 2-Chan. MUX t. PTC. Res. 2-Chan. MUX. VDD. S1. S0. CLK. Data. RST. OUT. VSS. COMP ... Power is supplied to the control IC through VDD and VSS. VDD is the positive ..... 81â3â3440â3569. 1â800â521â6274 or 480â768â2130.
The knock sensor is fitted to the cylinder block to detect engine knocking. This sensor contains a piezoelec- tric element which generates a voltage when it ...
the temperature difference between the measuring junction and the reference junction This constant of proportionality is known as the Seebeck coefficient and ...
Bank 1 refers to the bank that includes cylinder No.1. â¢. Sensor 1 refers to the sensor closer to the engine body. â¢. Sensor 2 refers to the sensor farther away from ...
Read freeze frame data using TOYOTA hand-held tester or OBD II scan tool. Because ... During cranking or idling, check between terminals G2 and. NE-, NE ...
Voltage output of the heated oxygen sensor remains at 0.40 V or more, or 0.50 V or less when the vehicle is driven at 40 km/h. (25 mph) or more after the engine ...