8 Series (ES8, CS8, CB8)Activity Monitoring System ... - FCC ID

of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage, et. (2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, ...
414KB taille 5 téléchargements 374 vues
8 Series (ES8, CS8, CB8) Activity Monitoring System Transmitter Module Installation Procedure

!

Compliance Statement (FCC part 15.19):

This device complies with Part 15 of the FCC rules. Operation is subject the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

!

Caution (Pertaining to FCC part 15.21):

Modifications to this equipment not expressly approved by GOJO Industries, Inc. could void the user's authority to operate the equipment.

!

Compliance Statement/Déclaration de Conformité (IC):

This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) L'appareil ne doit pas produire de brouillage, et (2) L'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement. This unit is certified to FCC Part 15 Part C for intentional unlicensed radiators.

FCC ID: 076-T6SG0910A IC: 10391B- T6SG0910A

1.

Press both cabinet latches to release the bottom portion of the cabinet.

3.

Remove the connector cover from the pumphouse.

5.

Load the dispenser with the appropriate product refill if needed.

4.

2.

Slide the bottom of the cabinet down to expose the pumphouse.

Insert the module into the left side of the pumphouse, pushing the front face until the module snaps into place.

6.

Slide the bottom portion of the cabinet up Wait 5 seconds for a flashing green LED. If red or no LED, open the cabinet to check for incorrectly installed refill or other issues. .