For the details about this module, please refer to the specification sheet of module. ... The following information must be indicated on the host device of this ...
User Manual Since this module is not sold to general end users directly, there is no user manual of module.
For the details about this module, please refer to the specification sheet of module.
This module should be installed in the host device according to the interface specification (installation procedure).
The following information must be indicated on the host device of this module; [for FCC] Contains Transmitter Module FCC ID: AK8M16DAM2 or Contains FCC ID: AK8M16DAM2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. *If it is difficult to describe this statement on the host product due to the size, please describe in the User's manual.
[for IC] Contains IC: 409B-M16DAM2
The following statements must be described on the user manual of the host device of this module;
[for FCC] FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body.
[for IC] This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) l’appareil ne doit pas produire de brouillage; 2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
5150-5350 MHz band is restricted to indoor operation only. La bande 5150-5350 MHz est restreinte à une utilisation à l’intérieur seulement.
High-power radars are allocated as primary users (i.e. priority users) of the bands 5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference and/or damage to LE-LAN devices. Les radars de haute puissance sont désignés utilisateurs principaux (c.-à-d., qu'ils ont la priorité) pour les bandes 5250-5350 MHz et 5650-5850 MHz, et ces radars pourraient causer du brouillage et/ou des dommages aux dispositifs LAN-EL.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment should be installed and operated keeping the radiator at least 20cm or more away from person’s body (※). Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement doit être installé et utilisé en gardant une distance de 20 cm ou plus entre le radiateur et le corps humain.
The following statement is for host manufacturer, therefore isn’t described on the user manual of the host device. This radio transmitter (IC: 409B-M16DAM2) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna type: PIFA, Gain: 6.4dBi (2.4GHz)/ 3.5dBi (5GHz) Antenna type: PIFA, Gain: 5.6dBi (2.4GHz)/ 5.0dBi (5GHz) Antenna type: PIFA, Gain: 5.6dBi (2.4GHz) Le présent émetteur radio(IC: 409B-M16DAM2) a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci‑dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Type d’antenne: PIFA, Gain: 6.4dBi (2.4GHz)/ 3.5dBi (5GHz) Type d’antenne: PIFA, Gain: 5.6dBi (2.4GHz)/ 5.0dBi (5GHz) Type d’antenne: PIFA, Gain: 5.6dBi (2.4GHz)
11 janv. 2017 - the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele
the device you want to listen to by stopping play on one device, then pressing play on the desired device. DUAL DEVICE OFF ... FACTORY RESET. Hold down MFB and Volume + Button at the same time for five seconds. CAUTION. Factory reset erases all paire
This device complies with part 15 of the FCC Rules. Operation is subject ... compliance could void the user's authority to operate the equipment. This transmitter ...
compliance could void the user's authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. [for IC]. 5150-5250MHz and 5250-5350MHz bands are restricted to indoor oper
User Manual. 5-5 Togoshi 6 Chome, Shinagawa-Ku, Tokyo 142-8511 Japan. Product Name: WLAN Complete Module. Model number: VRL4149-0601F. GENERAL. This product is a 2.4/5GHz Wireless Communication module that uses WLAN (Wireless. LAN) technology. This M
Operation is subject to the following two conditions: (1) this device may not ... Connect the equipment into an outlet on a circuit different from that to which.
Choose the Aux or S/PDIF mode. Connect one end of the included 3.5mm audio cable to the 3.5mm audio jack or the Toslink optical cable to the S/PDIF output on the BR-O2, and connect the other end of the cable to your audio output device (TV, computer,
Do not touch the product while switching the lamp on and off. Failure to do so may result in a burn. - You can check the list of compatible dimmers and transformers on the Samsung Electronics homepage or through the dealer you bought the lamp from. !
20 avr. 2017 - Information in this document is subject to change without prior notice. 2. 1. FCC & ISEDC Statement. 1.1. FCC Caution. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's au
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Expo
and relative humidity do not exceed 5 to 40È and 20 to 60%. 3) Assemble the modules within 6 months. Check the soldering ability in case of 6 months over. 3. Storage conditions. Parameter. Min. Typ. Max. Unit. Operating Temperature. 0. -. +70. È. O
directly. Therefore there is no user manual of this device. The following information must be described on the user manual of the vehicle;. User Manual.
17 juin 2015 - aux lois municipales, provinciales ou fédérales. Pour en savoir plus sur la mise au rebut ... Cet appareil ne doit pas être placé dans un meuble encastré comme une bibliothèque ou une étagère, à moins que ... de la classe B, conforméme
communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can ... the user is encouraged to try to correct
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. [for IC]. 5150-5250MHz and 5250-5350MHz bands are ...
17 juin 2015 - Do not place any sources of danger on .... find answers to frequently answered ... Note. ⢠If you press the button on the portable speaker, the portable speaker .... It may take around two hours to fully charge the ..... sheet on how
"apparel dot acceptertout brouillage radioélectrique Subi, méme sile brouillage est susceptible d'en comprometre lefonctionnement. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
User Manual. Product: PCIe Wireless Module. Model: SX-PCEAN2. For Solectria Renewables LLC integration only -- This device cannot be sold to the general public. FCC ID: 2AKA9 - SXPCEAN2. IC: 22112 - SXPCEAN2. The OEM must include the following notice
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IC RSS Warning. This device complies with
comply without testing of specific absorption ratio (SAR). [for IC]. This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and. (2) This devi
Regulatory Information. USA-Federal Communications ... for compliance could void the user's authority to operate the equipment. Labeling. System integrators ...
Risk of explosion if battery is replaced by an incorrect type. dispose of used ... instruct you on how to return the defective unit back to us for repair and .... Page 15 ...
