comply without testing of specific absorption ratio (SAR). [for IC]. This device complies with Industry Canada's licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and. (2) This device must accept any interference, including interference that may cause.
FUWC User Manual Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module. This module should be installed in the host device according to the interface specification (installation procedure). The following information must be indicated on the host device of this module; [for FCC] Contains Transmitter Module FCC ID: EJE-BT0004 or Contains FCC ID: EJE-BT0004
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. *If it is difficult to describe this statement on the host product due to the size, please describe in the User's manual.
The following statements must be described on the user manual of the host device of this module; [for FCC] FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other transmitter. (For Mobile Use) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE).
(For Portable) This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption ratio (SAR).
[for IC] This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions: (1) This device may not cause interference; and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes : 1) l’appareil ne doit pas produire de brouillage; 2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
(For Mobile Use) This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation de l’exposition maximale autorisée.
2
(For Portable) This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without testing of specific absorption ratio (SAR). Cet équipement est conforme aux limites d’exposition aux rayonnements énoncées pour un environnement non contrôlé et respecte les règles d’exposition aux fréquences radioélectriques (RF) CNR-102 de l’IC. Cet équipement émet une énergie RF très faible qui est considérée conforme sans évaluation du débit d’absorption spécifique (DAS).
This radio transmitter 337J-BT0004 identify the device by certification number or model number if Category II) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device. Antenna type: Pattern Gain: -2.0 dBi Antenna type: Monopole Gain: 0.7 dBi Le présent émetteur radio 337J-BT0004 a été approuvé par Industrie Canada pour fonctionner avec les types d'antenne énumérés ci ‑ dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitation de l'émetteur. Type d’antenne: Pattern Gain: -2.0 dBi Type d’antenne: Monopole Gain: 0.7 dBi
11 janv. 2017 - the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or tele
the device you want to listen to by stopping play on one device, then pressing play on the desired device. DUAL DEVICE OFF ... FACTORY RESET. Hold down MFB and Volume + Button at the same time for five seconds. CAUTION. Factory reset erases all paire
This device complies with part 15 of the FCC Rules. Operation is subject ... compliance could void the user's authority to operate the equipment. This transmitter ...
compliance could void the user's authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. [for IC]. 5150-5250MHz and 5250-5350MHz bands are restricted to indoor oper
User Manual. 5-5 Togoshi 6 Chome, Shinagawa-Ku, Tokyo 142-8511 Japan. Product Name: WLAN Complete Module. Model number: VRL4149-0601F. GENERAL. This product is a 2.4/5GHz Wireless Communication module that uses WLAN (Wireless. LAN) technology. This M
Operation is subject to the following two conditions: (1) this device may not ... Connect the equipment into an outlet on a circuit different from that to which.
Choose the Aux or S/PDIF mode. Connect one end of the included 3.5mm audio cable to the 3.5mm audio jack or the Toslink optical cable to the S/PDIF output on the BR-O2, and connect the other end of the cable to your audio output device (TV, computer,
Do not touch the product while switching the lamp on and off. Failure to do so may result in a burn. - You can check the list of compatible dimmers and transformers on the Samsung Electronics homepage or through the dealer you bought the lamp from. !
20 avr. 2017 - Information in this document is subject to change without prior notice. 2. 1. FCC & ISEDC Statement. 1.1. FCC Caution. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's au
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Expo
and relative humidity do not exceed 5 to 40È and 20 to 60%. 3) Assemble the modules within 6 months. Check the soldering ability in case of 6 months over. 3. Storage conditions. Parameter. Min. Typ. Max. Unit. Operating Temperature. 0. -. +70. È. O
For the details about this module, please refer to the specification sheet of module. ... The following information must be indicated on the host device of this ...
directly. Therefore there is no user manual of this device. The following information must be described on the user manual of the vehicle;. User Manual.
17 juin 2015 - aux lois municipales, provinciales ou fédérales. Pour en savoir plus sur la mise au rebut ... Cet appareil ne doit pas être placé dans un meuble encastré comme une bibliothèque ou une étagère, à moins que ... de la classe B, conforméme
communications. However, there is no guarantee that interfer- ence will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can ... the user is encouraged to try to correct
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. [for IC]. 5150-5250MHz and 5250-5350MHz bands are ...
17 juin 2015 - Do not place any sources of danger on .... find answers to frequently answered ... Note. ⢠If you press the button on the portable speaker, the portable speaker .... It may take around two hours to fully charge the ..... sheet on how
"apparel dot acceptertout brouillage radioélectrique Subi, méme sile brouillage est susceptible d'en comprometre lefonctionnement. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
User Manual. Product: PCIe Wireless Module. Model: SX-PCEAN2. For Solectria Renewables LLC integration only -- This device cannot be sold to the general public. FCC ID: 2AKA9 - SXPCEAN2. IC: 22112 - SXPCEAN2. The OEM must include the following notice
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. IC RSS Warning. This device complies with
Regulatory Information. USA-Federal Communications ... for compliance could void the user's authority to operate the equipment. Labeling. System integrators ...
Risk of explosion if battery is replaced by an incorrect type. dispose of used ... instruct you on how to return the defective unit back to us for repair and .... Page 15 ...
