O
Safety Technology International, Inc.
Safety Technology International (Europe) Ltd.
2306 Airport Road • Waterford, Michigan 48327-1209 Phone: 248-673-9898 • Fax: 248-673-1246 Toll Free: 800-888-4784 • E-mail:
[email protected] Web: www.sti-usa.com
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999 Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only) E-mail:
[email protected] • Web: www.sti-europe.com
+ BACKPLATE ASSEMBLY
#1
#2
#3
_
+
_
L
L
TO DEVICES
L
SINGLE DEVICE LIGHT MAINTAINED FOR LAMP VOLTAGE SEE CHART BELOW
L INSERT BUTTON ASSEMBLY INDEXING TABS INTO LAMP HOLDER SLOTS THEN TWIST CLOCKWISE AS SHOWN TO LOCK.
TO DEVICES
+ +
MULTIPLE DEVICES N/C LIGHT MAINTAINED SERIES WIRING
SWITCH ASSEMBLY SEE VIEW BELOW
BURNDY FORK TERMINAL #TP14-6F OR EQUIVALENT
NO NC
L L #2 O
L L #3 O
10271 STATION HOUSING RED, GREEN, WHITE, YELLOW AND BLUE 10272-S BACKPLATE ASSEMBLY (SMOKE COLOR ONLY)
SH PU
10A, 1/2 HP, 125/250 VAC 6A, 30 VDC MODELS WITH LT-1 TIMER: FORM C CONTACTS RATED 120 VAC, 3A 28 VDC, 3A
MULTIPLE DEVICES N/O LIGHT MAINTAINED PARALLEL WIRING
LAMP (SEE CHART) STANDARD #656 STATION LABEL
19001 SCREW #8-32 X 3/8 in. (1) PROVIDED
REMARQUES POUR *SS-2**7/LT1-UL: Pour les installations de contrôle d’accès, l’alimentation de la minuterie LT-1UL doit être fournie par une source homologuée UL294. Lorsque cet appareil est utilisé aux fins de contrôle d’accès, il doit faire partie d’un système de porte de sortie à accès contrôlé. Il incombe donc à l’AHJ local d’autoriser l’utilisation de cet appareil au lieu d’un capteur automatique. Pour les installations de sécurité plus renforcée, des délais inférieurs doivent être utilisés. Pour les modèles SS-2**7/LT1-UL, la minuterie intégrée doit être installée et utilisée suivant la fiche d’installation LT-1UL fournie. La cote maximale des modèles * SS-2**7/LT1-UL est de 30 VCC 3A.
TERMINAL BLOCK LEGEND SWITCH RATINGS CHART
NO
10277 SHELL WHITE
(-)
*SS-2007/LTLUL NOTES: For access control installations, power for the LT-1UL Timer must be supplied by a power source listed to UL294. When used for access S control, this device shall be used as part of an access controlled egress door system. It is up to the local AHJ to allow use of this device in place of an automatic sensor. For higher security installations, lower time limits should be used. For SS-2007/LTUL the enclosed timer is to be used and installed per the enclosed LT-1UL installation sheet. SS-2007/LTUL maximum rating 30 VDC 3A.
C - COMMON
C
(+)
BURNDY SPADE TERMINAL #NC14F2590 OR EQUIVALENT
NO
C
BUTTON ASSEMBLY 10111 (GREEN) 10110 (RED) LAMP HOLDER (PART OF SWITCH ASSEMBLY)
14-16 AWG
NO
C
19010 SCREWS #6-32 x 1 in. BACKPLATE TO ELECTRICAL BOX (2) PROVIDED
10112 SWITCH ASSEMBLY WITH SCREW TERMINALS SEE SWITCH RATINGS CHART
C
O
19021 GROUND LUG #10-32 x 3/8 in. (1) PROVIDED
RETAINING NUT
(+)
NC - NORMALLY CLOSED
_
L #1
VIEW SHOWING INSTALLATION OF LAMP HOLDER TO BUTTON ASSEMBLY
NO - NORMALLY OPEN
N/O
C
19015 ALLEN WRENCH 3/32 (1) PROVIDED
LAMP CHART TYPE
BASE
VOLTS
WATTS
AMPS
RADION PT. NO. OR EQUIVALENT
AVERAGE LIFE (Hrs.)
FILAMENT
T3-1/4 WEDGE
6.3
1.57
0.25
50N8079 / #555
3000
FILAMENT
T3-1/4 WEDGE
14
1.12
0.08
#658
15,000
FILAMENT
T3-1/4 WEDGE
28
1.68
0.06
50N8109 / #656
2500
Electronic warranty form at www.sti-usa.com/wc14
INSTALLATION OF SS-2007 SERIES STOPPER® STATION All specifications and information shown were current as of publication, and are subject to change without notice. 10278IS APRIL2011
TO DEVICES
