Renault TWINGO VDO&BORG

Solder the leads to the ST6245 dashboard controller according to the colours in the photo below. The microcontroller pin No 11 (read cable lead) should be ...
515KB taille 161 téléchargements 1028 vues
Using the C10 connecting cable. Solder the leads to the ST6245 dashboard controller according to the colours in the photo below. The microcontroller pin No 11 (read cable lead) should be lifted up (unplugged from its socket /de-soldered) - the pin must not be short connected to the ground of the dashboard (-). After reprogramming the dashboard controller the mentioned pin needn’t to be reconnected (by plugging-in or soldering) because there is a pull-down resistor inside the internal structure of the controller chip, which grounds the pin.

In the picture below, it is shown how to connect power supply voltage to the BORG dashboard of the Renault Twingo car make. Red cable lead (+) and black cable lead (-).

Elprosys Sp z.o.o. Automotive electronics, programming, chip tuning. 44-102 Gliwice, 140 Tarnogórska St., phone (+48 32) 301-2-301, fax (+48 32) 301-2-302