***URGENT: READ PRIOR TO ATTEMPTING INSTALLATION***
NOX-4 Series Onyx 4" LED Retrofit Always turn off main power before installation
INSTALLATION SHOULD BE CARRIED OUT BY YOUR LOCAL ELECTRICIAN.
WARNING: Fire/Electrical Hazard This equipment is intended to be installed only by qualified personnel. The installation must be made in accordance with the current edition to the National Electric Code and all applicable state and local building codes. The final installation must be approved by the appropriate qualified electrical/building inspector(s). Improper installation may result in a fire or electrical hazard. Be sure the electrical power to the circuit has been disconnected before installing this electrical system. AVERTISSEMENT : Fire / Risque électrique Cet équipement est destiné à être installé uniquement par du personnel qualifié . L’installation doit être faite en conformité avec l’édition actuelle du Code national de l’électricité et toutes étatiques et locales codes du bâtiment applicables . L’installation finale doit être approuvée par l’ inspecteur en électricité / bâtiment qualifié approprié ( s) . Une mauvaise installation peut entraîner un incendie ou un risque électrique . Soyez sûr de la puissance électrique vers le circuit a été coupée avant l’installation de ce système électrique .
All rights reserved. Harman Kardon is a ... The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc. and any use of such ...
Before commencing installation or maintenance, ensure electricity is switched off at the mains. 1. Fit the mounting bracket in the required position. Be aware of ...
While holding reflector cone or baffle in place, align three ... CONSTRUCTION recessed cans, please use the .... wise to release trim ring and reflector cone or.
Turn power OFF to the fixture. 2. Remove existing T8 4FT fluorescent lamp from the fixture. 3. Inspect the sockets and wiring to ensure they are in proper working ...
Beware of joists, water pipes and electric cables when drilling holes. 2. ... Aurora does not levy any WEEE disposal charges to its customers for affected WEEE.
Drill appropriate size holes at the marked locations and install the anchors. ... This product is safety listed for damp locations. ... CAUTION RISK OF FIRE.
All bulbs must be returned using a nationally recognized courier (i.e. FedEx, UPS or DHL) having the ability to track packages. We shall not be responsible for ...
24 mai 2013 - CK. +. -. RED. BLA. CK. RED. GREEN. N. O. TE: The SPD. T switch shown to change the LED colour is not included with the LED . Page 1 of 2 ...
Disconnect or turn off power before installation or servicing. ▻ Verify that supply ... Allow for some volume of airspace around the fixture. Avoid covering LED ...
Put the LED driver into the ceiling cut-out and position it at least 100mm from ... product from other waste types and recycle it responsibly at your local facilities.
dirt level and minimum light output which is acceptable to user. ... Disconnect or turn off power before installation ... Avoid direct eye exposure to the light source.
Installation and service of luminaires should be performed by a qualified licensed ... This luminaire has been properly packed so that no parts should have been.
A) Recessed Mounting. NOTE: The back plate is not needed for recessed mounting and may be discarded. 1. Cut a 3 1/4â diameter hole in the surface. 2. Feed the fixture wires through the hole, and connect the wires to a 24V transformer. 3. Compress t
The draft 34A/1659/CDV text: The distribution of luminous intensity shall be in accordance with that declared by the manufacturer. Fv = Km. â«. â. 0 d Fe (λ) d λ.
