MWK Tied Using The Wall Knot Method

Tie your wall knot, either CW or CCW, when your crowning is at desired length.

Now take each lead and take it through the next loop. This will make each strand go through 2 loops.

When all lead have gone through 2 loops, pull the slack out and tighten the stands loosely as shown.

At this point I roll the cords together and begin to pull the knot from the sides of the crowning to the top edge. You can tug on each strand to tighten it evenly around the edges

Your knot should now start to look like a narrow MWK but not flared out quit enough yet. The next step will position the knot correctly.

I tie an over two complex crown here and tighten it down into the center of the MWK. This sets the MWK out to full flare and evens it out to a solid knot

Continue with your crowning or add another MWK. Two crowns on top of the MWK will leave a small gap between MWKs. One crown will make the MWK lay together

Two MWKs with two crowns between them.