REMOVE DIRECT CLUTCH SPEED SENSOR. (a) Disconnect the connector. (b) Remove the bolt and direct clutch speed sensor. (c) Remove the O-ring from the ...
ON-VEHICLE REPAIR 1. REMOVE AIR CLEANER ASSEMBLY 2. REMOVE AIR CLEANER ASSEMBLY BRACKET Remove the 2 bolts and bracket and shift control cable clamp.
D07808
3. (a) (b) (c) 4. (a)
D05608
REMOVE DIRECT CLUTCH SPEED SENSOR Disconnect the connector. Remove the bolt and direct clutch speed sensor. Remove the O-ring from the direct clutch speed sensor. INSTALL DIRECT CLUTCH SPEED SENSOR Coat a new O-ring with ATF and install it to the direct clutch speed sensor. (b) Install the direct clutch speed sensor with the bolt. Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf) (c) Connect the connector. 5. INSTALL AIR CLEANER BRACKET Install the bracket with the 2 bolts. Torque: 19 N·m (195 kgf·cm, 14 ft·lbf) 6. INSTALL AIR CLEANER ASSEMBLY AND SHIFT CONTROL CABLE CLAMP
The No.1 vehicle speed sensor outputs a 4-pulse signal for every revolution of ... â¢Open or short in vehicle speed sensor circuit ... INSPECTION PROCEDURE.
GENERAL INSTRUCTIONS. ⢠All servicing operations and inspections in this section can be made with the engine installed. ⢠Drain the coolant before removing ...
Clutch Master Cylinder . .... Coat the master piston and the primary and secondary .... KA. HOLDER PIN. Hold the clutch center holder, loosen the clutch center.
GENERAL INSTRUCTIONS. ⢠All servicing operations and inspections in this section can be made with the engine installed. ⢠Drain the coolant before removing ...
Repair master cylinder. CL-6, 8. Clutch disc ...... MANUAL TRANSMISSION - Removal and Installation of Transmission. REMOVAL OF ...... reverse idler gear shaft end with the case installation holes, and install ...... BR 1840 BR 1036. BR1037.
Product and company names are trademarks or trade names of their respective companies. instruNet is a trademark of GWI. instruNet technology is patent ...
a stripped line to reduce effects of UV degradation. For further information ...... pas d'affichage intégré et nécessitent un PC équipé du logiciel rope sense ou un ...
Figure 2. 5. Run the cable through the printer as show on picture 3. The connector will be connected to the DIMM (on. 4200-4300) or CompactFlash (on ...
1/8. Simplification of the Shift/Clutch Operations for the Formula SAE Vehicles. (1). (1). (1). (2). Hiroshi ENOMOTO, Hironari MORITA, Yousuke FUKUNAGA and ...