Buetepanzer IV #210 "Bob" - Manualidades a Raudales

The 6 pounders were another matter. The Germans discovered that their 5.7 cm gun used in the A7V could be easily adapted to fit the. MkIV sponsons. There is ...
3MB taille 0 téléchargements 244 vues
The Germans captured large numbers of MkIV's, repaired them and used them against their former owners. The Germans had far more captured MkIV's than they did their own A7V tanks. The Germans considered replacing the Lewis machine guns with Maxims, but it was easier to re-chamber the Lewis to take the German '08 cartridge than to redesign the gun mounts. The 6 pounders were another matter. The Germans discovered that their 5.7 cm gun used in the A7V could be easily adapted to fit the MkIV sponsons. There is debate over the origin of the 5.7 cm guns. They are variously described as Belgian or Russian, sometimes as "Sokol" guns. The best information I have is that they were Nordenfeldt guns, designed by a Swede, made in England then sold to other nations, including Belgium and Russia, from whom the Germans captured them in sufficient quantity to equip their tanks. They added a hatch to the roof of the driver's cupola of some vehicles. Germany deployed its tanks in Units (abteilungen) of 5 at fu ll strength. Mix of male and female depended on how many of each had been captured and made serviceable. Assignment of individual tanks to a particular abteilung was usually permanent, but might change after a trip to the workshop. There were no battalions as such, or brigades. Vehicle #210, "Bob", was tank #3 in the 13th ATD (Sturmpanzer Abteilung) at Roux in 1918. Sepp Dietrich of WWII fame/infamy, was a sergeant in this unit. Other tanks in this unit were #201 "Max", #104 "Kathi", #112 "Marianne" and #103, "Kerlchen".

Buetepanzer IV #210 "Bob" Captured Mk IV (Male) WWI British Heavy Tank 1/72 Scale copyright 2006 Clifton W. McCullough

1

2

cut out

6-glue 3

spacer for right track frame as shown left track frame is similar

cut out right track frame as shown left track frame (4, 5 and 6) is similar

5-glue

7

3-glue

4-push 2-glue 1-glue

bottom

e dr f ol

8

t firs r a

top or

9a narrow tracks

9b wide tracks

12

9a (only) 11

ld fo

10

track spuds (10, 11) were used sometimes with narrow track (9a) only, one per 5 or 6 track links. Wide track (9b) was developed to provide traction similar to narrow tracks with spuds

d on c se nt o fr

WWI British Mk IV Heavy Tank Scale 1:72 Instructions Sheet 1 copyright 2005 Clifton W. McCullough

left German 5.7 cm gun mount as shown right side (39, 40, 41) is similar 37

cut out opening 13a 13

13 38

14a 15 form #15 into hemisphere

36 14b

12 16

cut #22 into 3 pieces 22 23

form #31 into 31 hemisphere

roll #36

71

25 x3

26

24

19 30

18 20 fold #27 into inverted "U"

form #35 into hemisphere

17

27

34

35

21 44

wrap # 49 around top of # 48x3

49 trim # 49

bend rear of rail two places as shown 53

52

left rail as shown; right rail (50,51) is similar but bends in opposite directions

bend front of rail as shown

48 laminate 3x #48

Captured WWI British Mk IV Heavy Tank (Male) Scale 1:72 Instructions Sheet 2 copyright 2005 Clifton W. McCullough

48

49 9a

56

9b

spud (10, 11) (if used)

55

61

right side as shown; left side similar 56

55 54

9a

60

57

59

58

47

below female sponsons only (47 on right, 44 on left)

end view with wide tracks

end view with narrow tracks Left Female Sponson Right sponson is similar 42

42 left female sponson

machine guns

34

machine gun may have been fitted in some MkIV in rear door

9b

left male sponson

30

Left male Sponson 34 British 33 38 German

43 43a

machine gun (Lewis MG or Hotchkiss MG in British tanks Lewis MG in Beutepanzers. 65 Note: some Beutepanzer female tanks were fitted with 13mm anti-tank rifle in front position only)

British 29 41 German

30

Right male Sponson

right male sponson

45

right frmale sponson

WWI British Mk IV Heavy Tank Scale 1:72 Instructions Sheet 3 copyright 2005 Clifton W. McCullough