Store in a cool place. Always wear protective equipment. Follow the application instructions mentioned in this TDS. Flash Point: 29°C / 84°F. Specific Gravity:.
BODY ALU 255 POLYESTER FILLER Technical Data Sheet No 502
General Technical Description VOC compliant with the regulations Two component polyester based putty with Aluminium, suitable for metallic and wooden surfaces It provides for a smooth, non porous surface Dries quickly
Mix 100 parts BODY 255 BODYALU with 2-3 parts Body Hardener
Surface Metallic and Wooden surfaces
Pretreatment / Cleaning of substrate Clean substrate using a soft cloth and BODY 770 ANTISIL NORMAL / BODY 771 ANTISIL FAST.
Non force dry 20-30 min / 23°C Make sure the surface is air dried rather than wiped dry
IR drying 5-8 min distance: 60-70cm
Easily sanded
Make sure you always use appropriate face protection and good ventilation
Product Application: Apply On Metallic And Wooden Surfaces 100:3 mix with BODY HARDENER Pot life: 4min / 23°C
HB BODY acrylic primers
Flash Point: 29°C / 84°F Specific Gravity: 1.80g /cm3
Apply with the spatula
Store in a cool place
Non force dry 20-30min /23°C
Always wear protective equipment
Short wave 5 – 8 min Lamp distance: 60 - 70cm
Follow the application instructions mentioned in this TDS
P 80 – P 120
Solid Content (No thinner): 85% Weight VOC (2004/42/EC) This product is a special refinish product based on its ingredients and its properties. The maximum VOC content in this category is 250g/L. The VOC content in the ready for use form of this product is 120 g/L. 2004/42/IIB(b)(250)120 Theoretical Coverage: Cleaning of equipment: Clean after final use with Body 767 EXTRA NITRO THINNER
Remarks: • Application only with Body Hardener. Mix well with putty. Do not add more than 3% as this may cause staining of the topcoat finish. • Do not apply to Etch Primer, 1K Filler, TPA substrates and soft old paintwork. • Do not apply at temperatures below +5°C • It can be used by countries that do not adopt the VOC legislation as well. • In temperature above 80 - 100°C (176 - 212°F) reduce the quantity of hardener by 50% to avoid the possibility of peeling. • Dry sanding is always recommended. • If wet flatting, dry thoroughly in the spray booth before any re coating. Storage shelf life: • Polyester materials have a limited shelf life. Store in a cool place (+5°C - +25°C) and use within 12 months for best results. Guaranteed shelf life of 18 months in unused original containers.
Hardener paste contains organic peroxide and is an oxidant. If hardener comes in contact with the skin, wipe off immediately and wash with soap and water. After eye contact irrigate copiously with water and seek medical advice immediately. For professional use only. The information displayed on this sheet has been carefully selected through a series of laboratory investigations. It is based on our best knowledge at the time of issue. The data is given for information purposes only. We are not liable for its correctness, accuracy and completeness. It is up to the user to check for newer updates or further information if needed for his intended purpose. The intellectual property of this product, trademarks and copyrights is protected. All rights reserved. The relevant Material Safety Data Sheet and warnings displayed on the label must be read carefully. We may modify and / or discontinue operation of all or portions of this information at any time in our sole discretion, without any notice and assume no responsibility to update the information. All rules set forth in this clause shall apply accordingly for any future changes and amendments.
Issue 2/2015, September 2015
HB BODY S.A. Auto Refinishing Products, Greece www.hbbody.com
BODY FIBER 250 POLYESTER FILLER. Technical Data Sheet ... regulations. Two component, polyester- based ... ents and its properties. The maximum VOC ...
Methods: Medical records were reviewed, and data regarding initial body weight and body ... Survival times were determined for dogs that were discharged from.
23-5 . . . . . . . Relay and Control Unit Locations ... 23-138 . . . . Seat Belt Reminder System ... Integrated Control Unit. Input Test ... Retractor Motor Test. 23-190.
âAugmented Body and Virtual Bodyâ was performed in, âUtopiales,â a festival in Nantes ..... language and its perception are the most important goal in terms of a.
power to cure him (this may require a successful. Perform .... circles within circles, built upon fundamental processes that ..... of joining the cosmic procession of the stars and sun. Adding ..... You have been called as a shaman for a Hyrkanian.
de calculer votre taux de masse grasse, musculaire et osseuse et donc de connaître votre composition corporelle. Mais ce n'est pas tout ce que Withings Body ...
23 oct. 2017 - présent règlement (ci-après le « Règlement »). Toute violation ... Les achats effectués avant ou après la Durée ne seront pas pris en compte.
Jan 19, 2009 - c. Click OK. d.Press + to save the document. e.Type [my first .... A strategic business approach that applies a consistent set of business solutions in support ... It is a feature-based, parametric solid modeling design tool that tak
Instalación de los pies para moqueta | Installazione dei piedini per moquette. 3 ..... iPad, iPhone and iPod touch are trademarks of Apple inc. Android is a ...
Utilisez cet appareil à une température comprise entre 5 et 35°C avec une ...... Généralement, un IMC compris entre 18 et 25 est considéré comme normal, ...
Standard on the MINI is a fully integrated Central Locking System. The Central .... the tailgate is through the electrical activation of the release motor. The tailgate ...
knowledge at the time of issue. ... discontinue operation of all or portions of this information at any time in our sole discretion, without any notice ... uct is 120 g/L.
If not, configuration which is set automatically by selecting vehicle model .... INPUT 1 - 5 outputs the voltage waveforms of 5 systems simultaneously. - It operates ...... AUTO LOCK SET. Auto door ... Buzzer: Sound Intelligent Key warning buzzer.
classes at your local health club, you'll find Zumba Fitness® to be like no other ..... All meals and snacks incorporate a balanced ratio of carbohydrates, fats, and ...
prechordal plate carry monocilia. â they beat to create a gradient of factors toward the left (Nodal flow). (Kartagener syndrom â immobile cilia â situs inversus is ...
If you've already made the jack plane featured on page 32 of issue. No. 79, this block plane will be a piece of cake. The construction is very similar to the jack ...
E . A E L T A E F N N I R 0 D S U C N N NN C T T0 T TA TE. S . 8 N B R T I A E R E B C .- Y P S A A AS 5 R n R T R . n. C S N N T T N S I R R RT L 0 CR CT 6 CE ...