2-Way Celling Speaker

the speaker. To remove the grille for painting, insert a paper clip into one of the grille openings then pull up. Or, you can carefully twist the plastic frame back and forth until the grille edge becomes exposed, then lift the grille to remove it.or use the grill remover to remove the grille. Carefully remove the dust cloth from.
Télécharger le PDF
139KB taille 5 téléchargements 404 vues
commentaire
Report
2-Way Celling Speaker OWNER'S MANUAL - Please read before using this equipment

INSTALLATION

paint mask and replace the grid. Paint Mask

PREPARING THE LOCATION To mount your speaker, you need the following items (not supplied, available at your local electronics store). drywall or keyhole saw wire stripper Phillips screwdriver pencil or marker

18-20 gauge speaker wire 1.

2.

Be sure the mounting surface is Between 3/8" (9.5mm) and 1 1/4" (31 mm) Thick, with at least a 2 3/4 (69mm) clearance behind the Mounting surface and no wall studs or other objects to block the back of the speaker.

CONNECTING THE SPEAKER WIRES Your local electronics store sells a wide selection of speaker wire. We recommend you use wire that is color-coded or marked on one side to help you connect the wire correctly

1. Route the speaker wire to the speaker from the receiver. U

2. Separate about 4"(101 mm) of Speaker wire at each end.

Remove the inner cardboard disc from the supplied template/paint

&DD (1/4')

mask and keep it for later. Use

the outer portion as a template to mark the cutout hole size and

location for mounting the speaker.

lOlnra (4")

3. Using a wire stripper, remove about 1/4"(6mm) of insulation from each wire. Then twist the ends of each wire.

4. Connect the marked wire to a red Speaker terminal by pressing the release tab, inserting the wire into the hole, and

\3 NOTE H Do not paint the speaker element We recommend you spray-paint the grille so paint does not block the holes.

3.

Use a drywall or keyhole saw to cut the hole, m

PREPARING THE SPEAKER If you choose to paint the frame and grille, paint them and let them dry before you connect the speaker wire or mount the speaker.

To remove the grille for painting, insert a paper clip into one of the grille openings then pull up. Or, you can carefully twist the plastic frame back and forth until the grille edge becomes exposed, then lift the grille to remove it.or use the grill remover to remove the grille.

then releasing the Tab. Repeat this procedure to connect the unmarked wire to the balck terminal.

5. Connect the marked wire coming from the speaker to the left channel of the receiver's positive (+) terminal. Then connect the unmarked wire to the left Channel of the amplifier's negative (-) terminal.

MOUNTING THE SPEAKER 1. Remove the grill to expose the mounting screws.

2. Be sure the mounting tabs are turned in, allowing the speaker to fit into the hole. Then insert the speaker into the mounting hole. 3. Use the four screws to tighten the mounting tabs to the wall or ceiling. Be careful not to over tighten the screws.

4. Replace the grille. 2 NOTE H Avoid routing the speaker wire near electrical wires.

Do not nail or staple the speaker wire.

Carefully remove the dust cloth from behind the grill and replace it after you are finished painting. You can also paint the frame to match your wall or ceiling. To prevent paint from entering the speaker, remove the grill and insert the supplied cardboard paint mask. After the paint is dry, remove the

Mounting Tabs

To remove the speaker from the wall or ceiling, loosen the screws only far enough to remove the speaker. This will prevent loss of the mounting tabs.