RMT-V197/V197A/V197B/V198/V198A/V198J/V198K/V199/V199A East European Model Greek Model SLV-E325EG/E475EG/E570EE/ E570EG/E720EE/E720EG
SERVICE MANUAL
French Model SLV-E715B/E720B/E720BZ
Irish Model SLV-E720EX
North European Model SLV-E720NC/E725NC
Spanish Model SLV-E720NP
UK Model SLV-E720UX
German Model
SUPPLEMENT-1
SLV-E717VC/E720VC
File this supplement with the service manual. (99-018)
Subject: EEP ROM INITIAL DATA INPUT
Austrian Model German Model SLV-E720VP
1. EEP ROM INITIAL DATA INPUT When EEP ROM (IC472 on FR-119 board) was changed, make it sure to input the data shown below and to perform “2-3-1. RF Switching Position Adjustment” .
5) Turn off the power 6) Disconnect the adjusting remote commander and LANC jig from the connector (CN164).
Input Method: 1) Connect the LANC jig (J-6090-051-A) to CN164 on MA-286 board. 2) Turn on the power. 3) Input Data: 80 in Address: 00 on Page: 1. 4) Input data on Page F as following table.
Note: When connecting or disconnecting LANC jig to CN164 on MA-286 board, first connect the adjusting remote commander (J-6082-053-B) to the jack on LANC jig before connecting LANC jig to CN164. Connection or disconnection of the adjusting remote commander in the condition LANC jig is connected to CN164 causes IC LINK (PS001) to damage itself.