1 / 4
SAFETY DATA SHEET SENTINEL PO 876 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE COMPANY/UNDERTAKING PRODUCT NAME
SENTINEL PO 876
APPLICATION
Process Oils
SUPPLIER
Univar 46 Peckover Street BRADFORD West Yorkshire BD1 5BD +44 1274 377000 +44 1274 377001
[email protected]
Emergency Contact Number (Outside (UK) 01372 222 000/ (IE) 44 1372 222 000 (SE) KEMIAKUTEN 020-99 60 00 alternativt Office Hours) SOS Alarm 040-676 90 40 (NO) Alarmsentral Brann Øst: 69 20 17 81
2 HAZARDS IDENTIFICATION Not regarded as a health or environmental hazard under current legislation. HUMAN HEALTH
High-pressure injection under skin may cause serious damage.
3 COMPOSITION/INFORMATION ON INGREDIENTS COMPOSITION COMMENTS
Severely treated paraffinic oils.
4 FIRST-AID MEASURES INHALATION
Move the exposed person to fresh air at once. Rinse nose and mouth with water. Get medical attention if any discomfort continues. INGESTION
NEVER MAKE AN UNCONSCIOUS PERSON VOMIT OR DRINK FLUIDS! DO NOT INDUCE VOMITING! Rinse mouth thoroughly. Get medical attention if any discomfort continues. SKIN CONTACT
Remove contaminated clothing. Wash skin thoroughly with soap and water. Get medical attention if any discomfort continues. If product is injected into or under skin, or into any part of the body, regardless of the appearance of the wound or its size, the individual should be evaluated immediately by a physician as a surgical emergency. Even though initial symptoms from high pressure injection may be minimal or absent, early surgical treatment within the first few hours may significantly reduce the ultimate extent of injury. EYE CONTACT
Promptly wash eyes with plenty of water while lifting the eye lids. Continue to rinse for at least 15 minutes. Get medical attention if any discomfort continues.
5 FIRE-FIGHTING MEASURES EXTINGUISHING MEDIA
Water spray, foam, dry powder or carbon dioxide. Do not use water jet as an extinguisher, as this will spread the fire. SPECIAL FIRE FIGHTING PROCEDURES
Water spray should be used to cool containers.
2 / 4
SENTINEL PO 876 UNUSUAL FIRE & EXPLOSION HAZARDS
By heating and fire, toxic vapours/gases may be formed. Oxides of: Carbon. Sulphur. Aldehydes. PROTECTIVE MEASURES IN FIRE
Self contained breathing apparatus and full protective clothing must be worn in case of fire.
6 ACCIDENTAL RELEASE MEASURES PERSONAL PRECAUTIONS
Wear protective clothing as described in Section 8 of this safety data sheet. ENVIRONMENTAL PRECAUTIONS
Do not discharge into drains, water courses or onto the ground. SPILL CLEAN UP METHODS
Stop leak if possible without risk. Absorb spillage with oil-absorbing material. Collect in containers and seal securely. Clean contaminated area with oil-removing material. In case of spills, beware of slippery floors and surfaces.
7 HANDLING AND STORAGE USAGE PRECAUTIONS
Avoid spilling, skin and eye contact. Avoid inhalation of vapours and spray mists. STORAGE PRECAUTIONS
Store in tightly closed original container in a dry, cool and well-ventilated place. Take precautionary measures against static discharges.
8 EXPOSURE CONTROLS/PERSONAL PROTECTION PROTECTIVE EQUIPMENT
ENGINEERING MEASURES
Provide adequate ventilation. Observe Workplace Exposure Limits and minimise the risk of inhalation of spray. When mist/aerosols can occur, the following are rekommended: 5 mg/m³ - ACGIH TLV, 10 mg/m³ - ACGIH STEL RESPIRATORY EQUIPMENT
No specific recommendation made, but respiratory protection may still be required under exceptional circumstances when excessive air contamination exists. HAND PROTECTION
Use suitable protective gloves if risk of skin contact. Nitrile gloves are recommended. EYE PROTECTION
If risk of splashing, wear safety goggles or face shield. OTHER PROTECTION
Wear appropriate clothing to prevent any possibility of skin contact. HYGIENE MEASURES
DO NOT SMOKE IN WORK AREA! Wash at the end of each work shift and before eating, smoking and using the toilet. Wash promptly if skin becomes contaminated. Promptly remove any clothing that becomes contaminated.
9 PHYSICAL AND CHEMICAL PROPERTIES APPEARANCE
Liquid
COLOUR
Brown
ODOUR
Characteristic
PHYSICAL DATA COMMENTS
DMSO Extract, IP-346: < 3%
SOLUBILITY
Practically insoluble in Water.
BOILING POINT (°C)
> 316 (600°F) > 2 @ 101 kPa
VAPOUR DENSITY (air=1)
RELATIVE DENSITY VAPOUR PRESSURE
900 kg/m³ @ 15 °C < 0.013 kPa @ 20 °C
3 / 4
SENTINEL PO 876 VISCOSITY
> 109 / > 5 cSt @ 40 °C / 100°C FLAMMABILITY LIMIT - LOWER(%) 0.9 PARTITION COEFFICIENT > 3.5
FLASH POINT (°C) FLAMMABILITY LIMIT - UPPER(%)
>246 (475°F) D-92) 7.0
(N-Octanol/Water)
10 STABILITY AND REACTIVITY STABILITY
Stable under normal temperature conditions. CONDITIONS TO AVOID
Avoid heat, flames and other sources of ignition. HAZARDOUS POLYMERISATION
Will not polymerise. MATERIALS TO AVOID
Strong oxidising substances. HAZARDOUS DECOMPOSITION PRODUCTS
None under normal conditions. Fire creates: Carbon monoxide (CO). Carbon dioxide (CO2). Aldehydes.
11 TOXICOLOGICAL INFORMATION TOXIC DOSE 1 - LD 50
> 2000 mg/kg
TOXIC CONC. - LC 50
> 5000 mg/m³
GENERAL INFORMATION
This product has low toxicity. Only large volumes may have adverse impact on human health. INHALATION
Vapours/aerosol spray may irritate the respiratory system. INGESTION
No harmful effects expected in amounts likely to be ingested by accident. SKIN CONTACT
Skin irritation is not anticipated when used normally. Product has a defatting effect on skin. Not a skin sensitiser. EYE CONTACT
Spray and vapour in the eyes may cause irritation and smarting. Other Health Effects
This substance has no evidence of carcinogenic properties.
12 ECOLOGICAL INFORMATION ECOTOXICITY
Not regarded as dangerous for the environment. MOBILITY
The product is insoluble in water and will spread on the water surface. BIOACCUMULATION
Accumulates in soil and sediment. DEGRADABILITY
The product is not readily biodegradable. ACUTE FISH TOXICITY
The product is not expected to be toxic to aquatic organisms.
13 DISPOSAL CONSIDERATIONS GENERAL INFORMATION
Waste is classified as hazardous waste. Make sure containers are empty before discarding (explosion risk). Do not puncture or incinerate even when empty.
(ASTM
4 / 4
SENTINEL PO 876 DISPOSAL METHODS
Dispose of waste and residues in accordance with local authority requirements. WASTE CLASS
European Waste Code: 13 02 05
14 TRANSPORT INFORMATION GENERAL
The product is not covered by international regulation on the transport of dangerous goods (IMDG, IATA, ADR/RID).
15 REGULATORY INFORMATION RISK PHRASES
NC
Not classified.
NC
Not classified.
SAFETY PHRASES APPROVED CODE OF PRACTICE
Classification and Labelling of Substances and Preparations Dangerous for Supply. Safety Data Sheets for Substances and Preparations.
16 OTHER INFORMATION GENERAL INFORMATION
Complies with the following national/regional chemical inventory requirements: AICS, IECSC, DSL, EINECS, KECI, PICCS, TSCA. DATE 2008-03-18 SIGNATURE
KL