Removing the HP Compaq dx2000MT Case Doors

ID de tutoriel : 6687 - Brouillon : 2019-06-24

Removing the HP Compaq dx2000MT Case Doors Remove the case doors

Rédigé par: Logan Pace

© iFixit — CC BY-NC-SA

fr.iFixit.com

Page 1 de 4

Removing the HP Compaq dx2000MT Case Doors

ID de tutoriel : 6687 - Brouillon : 2019-06-24

INTRODUCTION In this guide you will be removing the side case doors. This is a necessary step to replace every other component on the HP Compaq dx2000MT.

OUTILS: Anti-Static Wrist Strap (1) Flathead Screwdriver (1) Can be used instead of the Torx T15 and Phillips #2 screw drivers

Phillips #2 Screwdriver (1) T15 Torx Screwdriver (1)

© iFixit — CC BY-NC-SA

fr.iFixit.com

Page 2 de 4

Removing the HP Compaq dx2000MT Case Doors

ID de tutoriel : 6687 - Brouillon : 2019-06-24

Étape 1 — Case Doors 

Turn off your computer and remove the power cable by pulling it straight out of its socket.

Étape 2



Remove the two Phillips #2 screws that secure the case door to the device.

© iFixit — CC BY-NC-SA

fr.iFixit.com

Page 3 de 4

Removing the HP Compaq dx2000MT Case Doors

ID de tutoriel : 6687 - Brouillon : 2019-06-24

Étape 3



Remove the side case door by pushing towards the rear of the device with your hand.

 This may take considerable force so keep pushing! 

Once you slide the door back, remove it by pulling it outwards from the device.

Étape 4



Remove the side case door by pushing towards the rear of the device with your hand.

 Once again, this may take considerable force. 

Once you slide the door back, remove it by pulling it outwards from the device.

To reassemble your device, follow these instructions in reverse order. Ce document a été généré pour la dernière fois le 2019-07-08 07:44:12 PM.

© iFixit — CC BY-NC-SA

fr.iFixit.com

Page 4 de 4