Install by first disconnecting AC power on the panel. Next, remove the panel cover and disconnect the backup battery connector. Next, insert the Wi-Fi ...
RE926RX Wi-Fi Device Link Connect+™ Compatible Wi-Fi DeviceLink is a dedicated Wi-Fi module that is used to connect Wi-Fi devices directly to the panel.
Features
• Dedicated wireless connection to the panel • Secure encrypted wireless communications • 5-year warranty
Install by first disconnecting AC power on the
panel. Next, remove the panel cover and disconnect the backup battery connector. Next, insert the Wi-Fi DeviceLink into Slot 2 by carefully aligning the nylon retention posts and the 8-pin connector while pushing the card firmly until all posts are fully seated. Reconnect the backup battery and AC power. Finally, verify power and Wi-Fi LEDs are turned on, and then re-install the panel cover.
Align Retention Posts
Configuration is automatic and no other setup is required.
Align Connector
Install Wi-Fi DeviceLink in Slot 2
Remove AC Power
Slot 1
Slot 2
Slot 3
Backup Battery
Remove Backup Battery Use the panel installation guide to verify proper system setup.
Specifications Physical Dimensions
4.32 x 1.9 x 0.6 inches (centimeters)
Weight
0.7 ounces (20 grams)
Environmental Operating Temperature Maximum Humidity
32°F to 120°F (0°C to 49°C) 85% non-condensing relative humidity
Module Specifications Frequency
2.4 GHz
Certification RE926RX
FCC, IC, CE, RCM Specifications subject to change without notice
WARRANTY
FCC NOTICE
TRADEMARKS
(1) This device may not cause harmful interference. (2) This device must accept any interference that may be received, including interference that may cause undesired operation.
IC NOTICE
Changes or modifications not expressly approved by the Alula Holdings, LLC could void the user’s authority to operate this equipment.
Alula Holdings, LLC will replace non-portable products that are defective in their first five (5) years and all portable products that are defective in their first two (2) years. Alula and Connect+ are trademarks owned by Alula Holdings, LLC.
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of the device. Le présent appareil est conforme aux cnr d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions suivantes:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
CE DECLARATION OF CONFORMITY
Hereby, Alula Holdings, LLC declares that this RE926RX is in compliance with the essential requirements and other relevant provisions of directive 1999/5/EC. (This declaration can be translated to other languages via a myriad of translation tools found on the Internet.)
(1) L’appareil ne doit pas produire de brouillage, et (2) L’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
47-0039-00 • REV B • 2018-03-07 Tech Support Line • (888) 88-ALULA • (888) 882-5852 alula.net 01
the Connect+ Installer App or by entering its. 8-character serial number on the interactive service provider's web portal. Options for sending an Enrollment Signal.
Enroll the panic by placing the panel into wireless enrollment mode and pressing the red panic button. Alternatively, the panic can be enrolled by scanning its bar code using the. Connect+ Installer App or by entering its 8-character serial number on
5-year warranty. Enroll by placing the panel into wireless enrollment mode ... Current Draw. Transmitted Indications. 433.92 MHz. One Panasonic CR123A.
SET-400 & SET-366 Main Canopies ... equipment to the dealer where it was purchased for a full refund. ... any affirmation of the fact or promise with respect to the products except ... Strong Enterprises Owner's Manual. ... All Tandem jumps made on t
Distance Range between Router and A01-A60 Bulb: 115 feet (near line of sight) ... turned on and has been connected to the wireless router with a proper.
... button within the task bar to the left of the OW-SERVER-WiFi's webpage. You will be prompted for the default login credentials below: a. User Name = admin b.
Check if the powercord to the bulb has been disconnected or if the power .... This radio transmitter (identify the device by certification number, or model number.
2835 Columbia Street • Torrance, CA 90503 USA. Designed and intended for .... Wenn Sie während der Verbindung mit Ihrem Teleskop den Internetzugang auf.
Dec 1, 2016 - Packing Data Card (any style but must remain with reserve canopy throughout life) ...... Always trim end of line at 45 degree angle. Note!
control, that we want you to clearly understand that by using or intending to use our equipment, you are .... 4.0 Introduction . ...... While controlling âAâ line groups.
Google Wifi Setup. Welcome to Google Wifi. Wi-Fi is used in every part of the home: in the bedroom, in the kitchen, in the garage, everywhere. Google Wifi keeps ...
Your Cosmos 90gt WiFi telescope requires one of the following power sources: ..... visiter plusieurs des objets qui ont été vus sur la route de « l'engin spatial de.
29 sept. 2016 - Just go to www.irislink.com/start and download your new software. > Quick User guide/Warranty. If you want to download the PDF versions of the Quick user guides of our products please go to .... 3 Turn on the Wifi connection on your P
Apr 18, 2015 - completely in their power, and they were very nice to me, sharing their food and ..... much more than others, but being that the general fine art of ...
Single, red button with comfortable feel. ⢠Fully sealed, water resistant housing. ⢠Strong, reliable RF signal. ⢠âHeartbeatâ LED blinks every minute to assure user.
|13|: CiA DS-206 V1.1, Recommended Standard CAL Modul Data Sheet, ... Data link layer protocol for serial communication as specified in .... Basis Function.
