Module Installation Instructions And Regulatory Approval Conditions
12 mai 2015 - FCC Compliance Statement. This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) This ...
Module Installation Instructions And Regulatory Approval Conditions 802.11b/g/n Model No: 20001499 FCC ID: W38-20001499 IC: 8854A-20001499 Date: 5-12-2015 Revision: 1
FCC Compliance Statement This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Warning: Any changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Industry Canada This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."
Regulatory Approval Conditions for using 20001499 Module: 1. Antennas must have a greater distance than 20 cm separation from the transmitting antenna to the user body during normal operation condition. This device can be used with Prestta WLAN Embedded Antenna. The specification of the antenna including antenna gain is shown below.
2. If a different antenna than the original certificated antenna is being use for the final product, the host will need to consult with ChargePoint Inc. to verify the condition of approval applicability. 3. A permissive change from Coulomb Technologies Inc. is required as part of final system FCC/IC submission. 4. If the host has other transmitters beside from the module, simultaneous transmitting is not permitted unless a permissive change from the module manufacture is received. 5. For FCC, the label on the final system must include a statement: use “Contains FCC ID: W38-20001499”. For IC, use “Contains IC: 8854A20001499”. 6. Labeling requirement for FCC, “This device complies with part 15 of the FCC Rules. Operation is subjected to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation”. For IC, “This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.” “Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement."
A user’s manual or instruction manual must be included with customer product.
The specification of the antenna including antenna gain is shown below. 2. If a different antenna than the original certificated antenna is being use for the final.
FCC Warning: Any changes or modifications to this device not expressly approved by the party responsible for compliance could void the user's authority to ...
This module has been granted modular approval for mobile applications. ... to RF radiation, the maximum antenna gain including cable loss in a mobile-.
The Pass & Seymour/Legrand portable GFCIʼs rugged construction allows it to be used in outdoor or indoor locations, where ground fault protection is desired.
If your original motor had the pluggable motor switch (See Figures 2B and 2C), replace .... Switch connection #6 is the centrifugal switch normally open contact. 4. Switch connections #1 and #2 are the normally open heater contacts. 5. Switch ...
McGill Journal of Medicine .... Scientific Education Seminar Series; 1999. 9. ... chemical engineering, and has worked in the area of pharmaceutical approval and ...
Installation in Can ada must be in accordance with Natural Gas and Propane Installation Code, ...... cendre. Méthode 2 : La façon la plus facile de nettoyer le gril est de le faire juste après la cuisson, une fois le feu éteint. Portez un gant de bar
placed against an extended wall and the ability to remove the crisper pans is ...... REMARQUE : S'assurer de refixer la fiche technique derrière la grille de la ...
C. The fire department is being called. .... This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
product, check with the company handling the disposal about what to do. ... removed by rubbing a small amount of liquid dish soap over the adhesive with your ...
All safety messages will follow the safety alert symbol and either the word “DANGER” or .... temperature ranges from a minimum of 55°F (13°C) to a maximum.
ventilated and have at least 60 square inches open area for a ... 120 square inches of open area equally distributed. Caution! ..... stainless steel basket. â¡. â¡.
Install 900µm fan-out kit per manufacturer's instructions and place bare fiber protective boot on assembly and slide back. Ensure at least 2" of 250µm coated ...
Clean the ice making system per the instructions on pages 7 ..... for more great GE Appliances products and take advantage of all our on-line support ... You can purchase it on-line anytime, or call 800.626.2224 during normal business hours.
If your refrigerator without doors does not pass through the doorway, you may .... Firmly push the handle toward the door until the handle base is flush against ...
2 sept. 2016 - age access. The sealed .... Install the rear access cover with the vent tube coming out the upper .... age (à partir de l'étiquette à son extrémité) ...
The owners manual is shipped inside the product in a plastic bag along .... room, out of direct sunlight and away from heating ducts or registers. Do not place the ...
Do Not store or use gasoline or any other flammable vapors and liquids in the .... all parts of the unit are firmly in place and that the grill is stable (can't be tipped.
Spiders and insects can nest in the grill burners , causing gas not to flow ...... brush in a mixture of 2 cups of tap water and 1/2 cup of vinegar and scrub the hot ...
knowledge can use this appliance only if they are supervised or have been given instructions on safe use and understand the hazards involved. â¡ This ...
Dealer's name and address ...... walls, or in the form of droplets of ice or âiciclesâ... especial- ly in hot or .... 800.223.3900 for directions on how to obtain warranty.