Installation Instructions - GE Kitchen Appliances - GE Appliances
TO REDUCE THE RISK OF FIRE, USE ONL< METAL DUCTWORK. WARNING: TO ..... Route house wiring as close to the installation location as possible, in the ...
the gas burners resulting in fire or explosion hazard. ..... (6.4 mm) thick flame.retardant millboard ..... pressure test the gas supply system of the residence,.
of Pipes or wires. Plumbing ... codes.) ⢠Water connection is on the left side of the dishwasher. Install the hot water inlet line, using no less than ... and lay it on its back. NOTE: Do ... additionnel avec raccord 5/8 ou 7/8 po (D.I.) et d'une l
Remove house fuse or open circuit breaker before beginning ... Route house wiring as close to the installation location as ... Wire nuts. Phillips and flat-blade.
New construction installation with 25” deep openings ..... Both door faces should be 7/8” behind the front face of surrounding cabinets on either a stainless.
20.amp circuit breaker or time delay fuse. NOTE: Use of automatic, wireless, ..... box end wrench to loosen and remove and replace the broil orifice. D. Reverse ...
Phillips #2 Screwdriver. Saber Saw. Carpenter .... NPT internal thread of the house shut.off valve, taking care to ..... T.15 and #2 Phillips screwdrivers. â¡ Drill with ...
If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or death. Installation must be ...
Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. In Canada, installation must conform with the current. Natural Gas Installation Code, CAN/CGA.B149.1 or.
If you received a damaged dishwasher, you should immediately contact your ... Skill Level â Installation of this dishwasher requires ..... it on its back. Figure I.
Failure to follow these instructions can result in death, .... The unit will project forward, slightly beyond adjacent cabinetry ..... The wall bracket will be attached to.
Follow the instructions in the section Grounding the unit. ... 8. Refrigerator Location. 8. 1/4â Framed Panel Dimensions. 9. 3/4â Overlay ... Cut a notch in the top.
If it is necessary to install the valve behind the unit, it must be located in the shaded area. • Saddle type shut-off valves are included in many water supply kits, but.
Note to Consumer – Keep these instructions with your. Owner's ..... Install a shut-off valve (required) between the icemaker ..... Screw front legs all the way in.
Method 2 â âHigh Drain Loopâ with Waste Tee or Disposer. Special consideration ..... Make sure black, white and green dishwasher wires are threaded through ...
the shaded areas shown in Figure A for the drain hose connection. The hole ... connected to an individual properly grounded branch circuit protected by a 15 or ...
Keep these instructions and all orifices in case you want to convert back to natural gas. .... (A) Soft blue flamesâ. Normal for natural gas. (B) Yellow tips on.
your cabinets, check with your builder or cabinet ...... D. Replace the burner heads, caps and top grates. ... out the propane (LP) sticker and include your name,.
fixed house wiring or circuit breaker for disconnecting the ... or direct sunlight. ... with drawer closing or toekick installation. Refrigerator. Water Supply. House.
NOTE: Right-hand models illustrated. Allow the same clearances on the opposite side for left-hand fresh food models ZIFI240 and ZIFS240 only. Models ZIBI240 ...
used whenever the sides of the refrigerator will be exposed. The 1/4â. (0.63 cm) side panels will slip into the side case trim. Secure the panels to the refrigerator.
Observe all governing codes and ordinances. • Note to Installer – Be sure to leave these instructions with the .... Before installation or first use, we strongly advise that you polish the ... The drawer fronts are unfinished cherry wood. During.
For Monogram local service in your area, call 1.800.444.1845 or visit monogram.com. For Monogram service in Canada, call 1.800.561.3344 ...... Page 99 ...