CHECK OPERATION SOUND FROM EACH INJECTOR Connect the PCV hose to cylinder head cover. With the engine running or cranking, use a sound scope to check that there is normal operating noise in proportion to engine speed. (c) If you have no sound scope, you can check the injector transmission operation with your finger. If no sound or unusual sound is heard, check the wiring connector, injector signal from the ECM. (d) Disconnect the PCV hose from cylinder head cover. 3. INSPECT INJECTOR RESISTANCE (a) Disconnect the injector connector. (b) Using an ohmmeter, measure the resistance between the terminals. Resistance: 13.4 - 14.2 Ω at 20°C (68°F) If the resistance is not as specified, replace the injector. (c) Reconnect the injector connector. 4. INSTALL WIRE HARNESS PROTECTOR COVER (a) Install the wire harness protector cover with bolt and 2 nuts. (b) Connect the PCV hose to cylinder head cover.
in place by the metering rod screw No. 13. The metering rod and its shape are the ... Due to the efficiency of the fuel air mixture, the fuel consumption is less.
tube located in the center plate of the injector No. 4. ... the tube to exert pressure on the throttle slide No. ... By now you are saying, "This system is too good to be.
Mar 26, 2005 - Note that you need to use the 'downloaded' REQ_FUEL, .... However, a more elegant solution that continues to use PWM is the ... To assemble the flyback board, follow these instructions: ..... affect on fuel economy, since you likely ne