Owners Manual Power Gear H-point Mini Hydraulic Slideout System
CONTENTS Page
www.lci1.com
Operation
2
Manual Override
2
Preventive Maintenance
3
Troubleshooting
3
2
OPERATION HOW TO OPERATE YOUR SLIDE OUT:
WARNING The hydraulic slide out system is designed as a slide out system only. Use of the hydraulic slide out system for any other reason or function could result in damage to the coach and/or cause serious injury or even death. Check that potential parking locations are clear of obstructions, either permanent or temporary, before operation. Keep people clear of coach while operating the slide out system. Never expose hands or other parts of the body near hydraulic leaks. High pressure oil leaks may cut and penetrate the skin causing serious injury. Park the coach on a reasonably solid and level surface to optimize the slide out system function.
Room extension: 1. Level the unit. 2. Verify that the battery is fully charged and hooked up to the electrical system. 3. Remove the transit bars (if so equipped). 4. Turn “ON” the on/off switch or key (if so equipped). 5. Press and hold the IN/OUT switch in the OUT position until the room is fully extended and stops moving. 6. Release the switch, which will lock the room into position. 7. Turn “OFF” the on/off switch or key (if so equipped). Room retraction: 1. Verify that the battery is fully charged and hooked up to the electrical system. 2. Turn “ON” the on/off switch or key (if so equipped). 3. Press and hold the IN/OUT switch in the IN position until the room is fully retracted and stops moving. 4. Release the switch, which will lock the room into position. 5. Turn “OFF” the on/off switch or key (if so equipped). 6. Install the transit bars (if so equipped).
Read, study, and understand this manual before operating the slide out system.
MANUAL OVERRIDE Your Power Gear slide system is equipped with a manual override that allows you to retract the room in the event of a loss of power.
Counter-clockwise to open valve
NOTE: The room slide system cannot be manually pushed out using this method. It can only be pushed in so the RV can be taken to the nearest service center.
NOTE: If the room does not move when the switch is pressed, check the following: Make sure the room slide system is turned on Battery is fully charged and connected If pump runs but room does not move, be sure that the manual override valve on top of pump is closed (turn clockwise until valve stops to close valve). After the previous items have been checked and the room still does not move when the room slide switch is pressed, follow these simple steps to manually override your slide-out room. 1. 2. 3. 4. 5.
Turn ‘OFF’ the on/off switch. Locate the room slide power unit Locate manual override valve on top of pump block. Open the manual override valve by turning it counter-clockwise with a flat blade screwdriver. The room is now free to move. With the assistance of several people, push room in. Tighten the manual override valve with a flat blade screwdriver. Take to your authorized dealer for service.
3
PREVENTIVE MAINTENANCE Caution: Do not work on your slide out system unless the battery is disconnected.
Your Power Gear slide-out system has been designed to require very little maintenance. To ensure the long life of your slide-out system, read and follow these few simple procedures:
1. There is no requirement to change the Pentosyn hydraulic fluid. Pentosyn® CHF-11S is also used as a power steering fluid in the following automobiles: Volkswagen, Mercedes, Audi, Peugeot, Saab, Jaguar, and some models of Daimler-Chrysler. Pentosyn® CHF-11S is recommended due to excellent performance in extreme heat and cold. It also has a long life and doesn’t thicken when the RV is in storage 2. Check the fluid level periodically. Under normal usage, fluid should not have to be added. Immediately investigate and correct any leaks, as the system is designed to be leak-tight. Fluid level may be checked with room in any position.
Fill Line
3. Inspect and clean all hydraulic pump electrical connections every 12 months. 4. Be sure that slide room is free of obstacles before attempting to open or close the room.
TROUBLESHOOTING If the room does not move when the switch is pressed, check the following:
Make sure the slide out system is turned on.
Battery is fully charged and connected
The transit bars are removed (if so equipped).
Blown fuse or circuit breaker. Fuse and circuit breaker locations are coach specific. Contact coach manufacture for locations of fuse and circuit breaker panels.
Driver and passenger seats are in forward position (if necessary).
Parking brake is engaged (if necessary).
Transmission is in park or neutral (if necessary).
If pump runs but room does not move, be sure that the manual override valve on top of pump is closed (turn clockwise until valve stops to close valve)
Refer to page 2 for instructions on manually retracting the slide out room.
STOP. -BALL. Hydraulic Power Lift Unloading Valve Assemblies gnly three items on the Hydraulic Power Lift have been affected by changes since the introduc-.
Use a sturdy stool or ladder when you clean, maintain or repair the air conditioner at a height. Failure to do so may result in serious injury or product failure.
ure to do so may result in electric shock or product failure. ... It may result in death, serious injury, or product failure. ..... The temperature range is 64°F(18°C)-.
Nation Electrical Code NFPA 70/ANSI C1-1003 or current edition and Canadian ..... P. J G. Navigation and functions button*:. Sets the special functions.
block the air flow or weaken the cooling / dehumidifying functions. For your records ...... 4 Botón del ventilador : El aire sale de la uni- dad interior por la parte ...
Select 5 if you want natural air. The fan speed adjusts .... pollution (or something like that). CAUTION ... In summer, it may take some time to cool indoor air.
ENGLISH. TIPS FOR SAVING ENERGY. Here are some tips that will help you minimize the power consumption ...... blinds or furniture blocking the front of the.
season, in order to prevent mold from setting in. This mode .... If the air conditioner will not be used for an extended of time, dry the air conditioner to maintain it.
purposes. Write the model number and the serial number here: ..... Cooling-only models do not support this ...... L Bouton de réglage de la vitesse du ventilateur.
The information contained in the manual is intended for use by a qualified service technician ..... from °C to °F if pressed for 5 seconds. m n ... Point the remote control towards the signal receiver ...... 3 Pulse g para ajustar la velocidad del
formance of your product. WARNING .... Contact an authorized service center when the air conditioner is submerged into water due to flood- ing. Failure to do so ...
Here are some tips that will help you minimize the power consumption when you use the air .... When there is a gas leak, ventilate sufficiently before using the air conditioner again. Failure to do so ..... The AM/PM icon flickers at the bottom of.
Keep doors or windows closed tightly while you are operating the air .... Do not mix the batteries for the remote control with other types of batteries or mix new batteries with ... Page 7 ... The feature can be changed according a type of model.
endommager la console, affecter son bon fonctionnement, ou provoquer la perte de ...... Un champ magnétique puissant, comme celui émis par un haut-parleur audio ..... Le présent mécanisme respecte l'article 15 des règlements de la FCC et ...
Do not touch, operate or repair the air conditioner with wet hands. It may result in electric ..... humidity or in the rainy season, in order to prevent mold from setting.
Ne placez aucun objet sur le cordon d'alimentation Cela peut provoquer un choc électrique ou la défaillance du produit. Installation. • N'installez pas le ...
Install the panel and the cover of the control box safely. Failure to do so may result in ..... If the air conditioner will not be used for an extended of time, dry the air conditioner to maintain it ... 4 Clean the filter with a vacuum cleaner or wi
The StreetPass feature allows your system to automatically search for and ...... Before using this feature, download the free Nintendo 3DS Transfer Tool from ...
buying video game systems, accessories, games and ... videos about software, or download software to play on your system. NOTE: A ... Format System Memory.
Dust and impurities collected in the air filter may block the air flow ... The information contained in the manual is intended for use by a qualified service technician.
