declare under our sole responsibility that the following product/s Electromechanical Relay Types QY… Basic part number followed by a varying length of alpha numerics to signify variant to which this declaration relates, are in:Conformity with the requirements of the following standards and other normative documents EN61810-1:2008
Electromechanical non-specified time all-or-nothing relays. General requirements.
and therefore conform to the protection requirements of the Council Directives 2006/95/EEC
An optional 14003638-001 mounting kit is available for direct mounting to ... (25mm) to the second hole. ... mier trou et un deuxième trou, à 25 mm (1 po) du pre-.
The range of RH plug-in control relays with single socket type common to all models and standard front face includes the .... the backbone of the automated system, it consists of a series of "step modules" ... associated with the step (motors, etc.)
0. 0.5. 1.0. 30 V DC resistive load. 125 V AC resistive load. Ratio against the rated .... Tested sample: TQ2-L-12V, 6 pcs. 13.-(1) Influence of adjacent mounting. Y.
Operate time*3 (at nominal voltage). Max. ... Nominal operating power .... ADOBE PDF-file produced January, 1999 / Technical data may change without notice.
contact assembly is electrically isolated from all the others, and the contacts .... Contact spacing can be wide, to protect from arc-over at high voltages. Capacity ...
These mechanisms aim at simplifying the network management, at reducing its cost of ... Dynamic self-optimization targets on-line network implementation of SON ... optimal controller is to be used as expert knowledge during the next phase. ...... Fil
Insitute of Health Sciences, Thames Valley University, Londres, R-U ..... peut être appliquée en toute sécurité sur un membre inférieur, notamment s'il existe un.
Certain models of Magnaflite starter drives malfunctioning. Check SB for ... Supercedure of Magnaflite starters with new E-Drive & X-Drive starters. SIL A-132.